R8102 TTS Sound Decoder Class 37
Hornby R8102 TTS Sound Decoder.
1 LEFT In Stock Ready to Order!
£43. FREE P&P
Olivia’s Fitting Service: £30
1 Day Service for Fitting to Hornby or Bachmann Loco’s
Return P&P Options of £5 Recorded or £10 Next day Special Delivery.
IMPORTANT – The decoder does not support sound under DC (Analogue) operation. Sounds can only be played under DCC (digital) operation. This applies to all sounds, both running and spot sounds.
The locomotive’s motor may be controlled under DC (Analogue) operation.
Please note we advise isolating the circuit board with isolation tape to prevent shorting prior to fitting the decoder.
F0 Headlight/rearlight (if fitted to locomotive)
F1 Engine start/stop
F2 Horn high-low
F3 Horn low-high
F4 Brake squeal
F5 NOTCH up
F6 NOTCH down
F7 Return to IDLE
F9 Cold start override
F11 Door slam
F13 Horn high
F14 Horn low
F16 Slow flange squeal
F17 Spirax valve
F18 Horn short low
F19 Horn short high
F20 Wagons buffering
F21 Wagons clanging
F22 Alternative door slam
F23 Guard’s whistle
F24 locomotive buffering
F25 Aux (if used in locomotive)
– Supports short and long decoder addresses
– Adjustable acceleration and deceleration
– Back EMF load compensation
– Up to 19 controllable spot sounds dependent on model including whistles or horns etc
– Two sound channels allowing for simultaneous play of full locomotive engine sounds, & individual spot sounds e.g. horns, whistles, brakes, wagons coupling etc. NOTE: Only one spot sound can be played at the same time
– It is possible to alter the volume of each sound through an individual dedicated CV. Range 0-8
– Decoder is equipped to support directional front and rear lighting operation via F0 on the controller, providing that the product is fitted with lights
– The decoder is equipped with 1 aux function output controlled by F18 or F25 dependent on locomotive type (diesel or steam)
– Motor current – maximum continuous 500mA
– Motor current – peak 1amp (no function load)
– Function output current maximum—100mA (unprotected)
– Decoder current maximum continuous – 800mA (shared motor and functions)
– Number of sound channels – 2
– Termination – 8 pin plug NEM652. NMRA
Free First Class Recorded Delivery.
Tel: 0114 3216 160 Or 0114 2647 449.